2013

The location of the donut is set based on the center point. After you specify
the diameters, you are prompted for the locations at which to draw donuts.
A donut is drawn at each point specified (2). How the interior of a donut is
filled depends on the current setting of the
FILL (page 435) command.
See also:
Draw Donuts
DRAGMODE
Controls the way dragged objects are displayed.
Access Method
Command entry: 'dragmode for transparent use
List of Prompts
The following prompts are displayed.
Enter new value [ON (page 364)/OFF (page 365)/Auto (page 365)]
<current>: Enter an option or press Enter
On Permits dragging, but you must enter drag where appropriate in a drawing
or editing command to initiate dragging.
364 | Chapter 2 Commands