2013

Table Of Contents

Summary

In general, the DIST command reports 3D distances in model space and 2D

distances on a layout in paper space.

In model space, changes in X, Y, and Z component distances and angles are

measured in 3D relative to the current UCS.

In paper space, distances are normally reported in 2D paper space units.

However, when using object snaps on model space objects that are displayed

in a single viewport, distances are reported as 2D model space distances

projected onto a plane parallel to your screen.

List of Prompts

The following prompts are displayed.

Specify first point: Specify a point

Specify second point or <Multiple points>: Specify a second point

The distance is displayed in the current units format.

DIST assumes the current elevation for the first or second point if you omit

the Z coordinate value.

NOTE When using the DIST command for 3D distances, it is recommended that

you switch to model space.

Multiple Points If you specify multiple points, a running total of the distance

based on the existing line segments and the current rubberband line is

displayed in the tooltip. A dynamic dimension is also displayed. The distance

is updated as you move the cursor.