2013

Zero Suppression
Controls the suppression of leading and trailing zeros and of feet and inches
that have a value of zero. (
DIMALTZ (page 1257) system variable)
Leading
Suppresses leading zeros in all decimal dimensions. For example, 0.5000
becomes .5000.
Sub-units factor
Sets the number of sub units to a unit. It is used to calculate the dimension
distance in a sub unit when the distance is less than one unit. For example,
enter 100 if the suffix is m and the sub-unit suffix is to display in cm.
Sub-unit suffix
Includes a suffix to the dimension value sub unit. You can enter text or use
control codes to display special symbols. For example, enter cm for .96m to
display as 96cm.
Trailing
Suppresses trailing zeros in all decimal dimensions. For example, 12.5000
becomes 12.5, and 30.0000 becomes 30.
0 Feet
Suppresses the feet portion of a feet-and-inches dimension when the distance
is less than 1 foot. For example, 0'-6 1/2" becomes 6 1/2".
0 Inches
Suppresses the inches portion of a feet-and-inches dimension when the
distance is an integral number of feet. For example, 1'-0" becomes 1'.
Placement
Controls the placement of alternate units in dimension text.
After Primary Value
Places alternate units after the primary units in dimension text.
Below Primary Value
Places alternate units below the primary units in dimension text.
346 | Chapter 2 Commands