2013

Dimension Line Location Determines where the dimension line is located
on the constrained object.
Object
Selects an object instead of a constraint point.
See also:
Apply Dimensional Constraints
DDEDIT
Edits single-line text, dimension text, attribute definitions, and feature control
frames.
Access Methods
Menu: Modify  Object  Text  Edit
Shortcut menu: Select a text object, right-click in the drawing area, and
click Edit.
Pointing device: Double-click a text object.
List of Prompts
The following prompts are displayed.
Select an annotation object or [Undo]:
Object Selection Displays the appropriate editing method for the type of text
you select:
 Text created using TEXT (page 1078) displays the In-Place Text Editor (page
678) without the Text Formatting toolbar and the ruler.
 Text created using
MTEXT (page 677) displays the In-Place Text Editor (page
678).
 Attribute definitions (not part of a block definition) display the
Edit Attrib-
ute Definition dialog box
(page 270).
 Feature control frames display the
Geometric Tolerance dialog box (page
1092).
DDEDIT repeats the prompt until you press Enter to end the command.
Undo Returns the text or attribute definition to its previous value. You can
use this option immediately after editing.
D Commands | 269