2013

The following table outlines the valid contraint objects and points:
CharacteristicsValid Objects or Points
Line
 When a line or an arc is selected, the
horizontal distance between the end-
points of the object is constrained.
Polyline segment
Arc
Two constraint points on objects
List of Prompts
The following prompts are displayed.
Specify first
constraint point (page 265) or [Object (page
265)] <Object>: Pick a constraint point or select an object
Constraint Point
Specifies a constraint point for the object.
First Constraint Point Specifies the first point of the object to be constrained.
Second Constraint Point Specifies the second point of the object to be
constrained.
Dimension Line Location Determines where the dimension line is located
on the constrained object.
Object
Selects an object instead of a constraint point.
See also:
Apply Dimensional Constraints
DCLINEAR
Creates a horizontal, vertical, or rotated constraint based on the locations of
the extension line origins and the dimension line.
Access Methods
Button
D Commands | 265