2013

Arc
Selects an arc and constrains the angle.
Dimension Line Location Determines where the dimension line is located
on the constrained object.
3Point
Selects three valid constraint points on the object.
Angle Vertex Specifies the angle vertex, which is at the center point of the
constraint.
First Angle Constraint Point Specifies the first angle endpoint of the arc.
Second Angle Constraint Point Specifies the second angle endpoint of the
arc.
Dimension Line Location Determines where the dimension line is located
on the constrained object.
See also:
Apply Dimensional Constraints
DCCONVERT
Converts associative dimensions to dimensional constraints.
Summary
This command is equivalent to the Convert option in
DIMCONSTRAINT (page
289).
Objects other than associative dimensions are ignored and filtered from the
selection set.
List of Prompts
The following prompts are displayed.
Select associative dimensions to convert: Select the associative
dimensions to be converted to dimensional constraints
See also:
Apply Dimensional Constraints
D Commands | 261