2013

If you select a surface, the Rebuild Surface dialog box (page 250) is displayed.
If you select a spline, the
Rebuild Curve dialog box (page 251) is displayed.
See also:
Edit NURBS Surfaces
Rebuild Surface Dialog Box
Rebuilds the CV hull of a NURBS surface.
Summary
Reshapes a NURBS surface by rebuilding the CV hull.
List of Options
The following options are displayed.
Control Vertices Count
Specifies the number of control vertices in the U and V directions.
In U Direction
Specifies the number of control vertices in the U direction. (
REBUILDU (page
1458) system variable)
In V Direction
Specifies the number of control vertices in the V direction. (
REBUILDV (page
1458) system variable)
Degree
Specifies the number of control vertices available per span. The higher the
number, the more complex the surface.
250 | Chapter 2 Commands