2013

objects converted to surfaces
You can select the objects to convert before you start the command.
NOTE You can create surfaces from 3D solids with curved faces, such as a cylinder,
with the
EXPLODE (page 411) command.
The
DELOBJ (page 1251) system variable controls whether the geometry used
to create 3D objects is automatically deleted when the new object is created
or whether you are prompted to delete the objects.
List of Prompts
The following prompts are displayed.
Select objects Specifies one or more objects to convert to surfaces.
If one or more objects in the selection set are invalid for the command, you
will be prompted again to select objects.
234 | Chapter 2 Commands