2013

CHANGE
Changes the properties of existing objects.
List of Prompts
The following prompts are displayed
Select objects (page 192):
Specify
change point (page 192) or [Properties (page 193)]:
Specify a new point, or press Enter to enter new values
Specify Objects
If you select lines and other changeable objects in the same selection set, you
get varying results depending on the object selection sequence. The easiest
way to use CHANGE is to select only lines in a selection set or select only
objects other than lines in a selection set.
Except for zero-thickness lines, the objects selected must be parallel to the
current user coordinate system (UCS).
Change Point or Values
Changes the selected objects. The result depends on the type of objects you
select.
Lines Moves the endpoints of the selected lines that are closest to the change
point to the new point, unless Ortho mode is on. If Ortho mode is on, the
selected lines are modified so that they become parallel to either the X or the
Y axis; their endpoints are not moved to the specified coordinate.
Circles Changes the circle radius. If you selected more than one circle, the
prompt is repeated for the next circle.
Text Changes text location and other properties.
192 | Chapter 2 Commands