2013

Undo
Reverses the previous action in the command.
Polyline
Chamfers an entire 2D polyline.
The intersecting polyline segments are chamfered at each vertex of the polyline.
Chamfers become new segments of the polyline.
If the polyline includes segments that are too short to accommodate the
chamfer distance, those segments are not chamfered.
Distance
Sets the distance of the chamfer from the endpoint of the selected edge.
If you set both distances to zero, CHAMFER extends or trims the two lines so
they end at the same point.
Angle
Sets the chamfer distances using a chamfer distance for the first line and an
angle for the second line.
C Commands | 189