2013

Entering a positive value draws the height along the positive Z axis of the
current UCS. Entering a negative value draws the height along the negative
Z axis.
The base of the box is always drawn parallel to the XY plane of the current
UCS (work plane). The height of the box is specified in the Z-axis direction.
You can enter both positive and negative values for the height.
Center
Creates the box by using a specified center point.
Cube Creates a box with sides of equal length.
Length Creates a box with length, width, and height values you specify. The
length corresponds to the X axis, the width to the Y axis, and the height to
the Z axis.
158 | Chapter 2 Commands