2013

Island Detection Specifies whether boundary uses objects within the
outermost boundary as boundary objects. For information about specifying
island detection at the Command prompt, see the HATCH (page 473) Command
prompt option.
Object Type Specifies the type of object that boundary creates.
 Region
 Polyline
See also:
Create and Combine Areas (Regions)
BOX
Creates a 3D solid box.
Access Methods
Button
Toolbar: Modeling tool set  Solids - Create tool group  Solid
Primitives flyout  Box
Menu: Draw  3D Modeling  Box
List of Prompts
The following prompts are displayed.
Specify first corner or [Center (page 158)]: Specify a point or enter
c for center
Specify other corner or [
Cube (page 159)/Length (page 159)]:
Specify the other corner of the box or enteran option
If the other corner of the box is specified with a Z value that differs from the
first corner, then no height prompt is displayed.
Specify height or [2Point (page 159)] <default>: Specify the height
or enter 2P for the 2 Point option
B Commands | 157