2013

Attributes of the selected block are displayed in the attribute list. By default,
Tag, Prompt, Default, Mode, and Annotative attribute properties are displayed
in the attribute list. For each selected block, a description below the attribute
list identifies the number of its instances in the current drawing and in the
current layout.
You can specify which attribute properties you want displayed in the list by
right-clicking over the attribute headers and choosing the ones to display.
Double-click an attribute to display the
Attribute Editor dialog box (page 135),
where you can modify attribute properties.
List of Options
The following options are displayed.
Select Block
You can use your pointing device to select a block from the drawing area.
When you choose Select Block, the dialog box closes until you select a block
from the drawing or you cancel by pressing ESC.
If you modify attributes of a block and then select a new block before you
save the attribute changes you made, you are prompted to save the changes
before selecting another block.
Block
Lists all block definitions in the current drawing that have attributes. Select
the block whose attributes you want to modify.
List of Attributes
Displays the properties of each attribute in the selected block.
Remove
Removes the selected attribute from the block definition. If Synchronize Blocks
is clicked and then Synchronize is clicked in the Synchronize Blocks dialog
box, the attribute is removed from all instances of the block in the current
drawing.
Found in Drawing
Reports the total number of instances of the selected block in the current
drawing.
Found in Current Layout
Reports the number of instances of the selected block in the current model
space or layout.
134 | Chapter 2 Commands