2013

By default, the format for displaying measured values differs slightly from the
format used for entering them. (You cannot include spaces when entering
measured values.)
Displays fractional, feet-and-inches, and surveyor's angles in “report”
format using spaces as delimiters
0
Displays fractional, feet-and-inches, and surveyor's angles in “input”
format without including spaces and, in some cases, substituting
dashes for spaces
1
See also:
Specify Units and Unit Formats
UOSNAP
Determines whether object snapping is active for geometry in PDF underlays
that are attached to the drawing.
IntegerType:
RegistrySaved in:
1Initial value:
UOSNAP overrides the
PDFOSNAP (page 1428) setting. Conversely, you can
override the UOSNAP setting for PDF underlays with the PDFOSNAP system
variable.
Object snapping is disabled for geometry in all underlay attachments
in the drawing.
0
Object snapping is enabled for geometry in all underlay attachments
in the drawing.
1
Object snapping is determined by the individual object snap under-
lay settings.
2
See also:
Use Object Snaps with PDF Underlays
1532 | Chapter 4 System Variables