2013

Verify Prompts for verification that the attribute value is correct when you
insert the block.
Preset Sets the attribute to its default value when you insert a block containing
a preset attribute.
Lock Position Locks the location of the attribute within the block reference.
When unlocked, the attribute can be moved relative to the rest of the block
using grip editing, and multiline attributes can be resized.
NOTE In a dynamic block, an attribute's position must be locked for it to be
included in an action's selection set.
Annotative Specifies that the attribute is annotative.
Multiple Lines Specifies that the attribute value can contain multiple lines
of text. When this option is selected, you can specify a boundary width for
the attribute.
Attribute Tag Name
Specifies the attribute tag, which identifies each occurrence of an attribute in
the drawing. The tag can contain any characters except spaces or exclamation
marks (!). Lowercase letters are automatically changed to uppercase.
Attribute Prompt
Specifies the prompt that is displayed when you insert a block containing this
attribute definition. If you press Enter, the attribute tag is used as the prompt.
If you turn on Constant mode, this prompt is not displayed.
NOTE For single-line attributes, you can enter up to 256 characters. If you need
leading blanks in the prompt or the default value, start the string with a backslash
(\). To make the first character a backslash, start the string with two backslashes.
Default Attribute Value
Specifies the default attribute value. The default attribute value appears when
a block is inserted into your drawing. A default value is not required. If you
turn on Constant mode, the Attribute Value prompt is displayed instead.
When Multiple Line mode is off, -ATTDEF then displays the same prompts as
the TEXT command, using the attribute tag instead of requesting a text string.
Current text style: "Standard" Text height: 0.2000
Specify start point of text or [Justify/Style]: Enter an option or press Enter
Specify paper text height <current>: Specify a height, or press Enter
The Specify Paper Text Height prompt is displayed only if the current text
style is annotative.
118 | Chapter 2 Commands