2013

Specifies the Z coordinate of the attribute's insertion point.
See also:
Define Block Attributes
-ATTDEF
List of Prompts
The following prompts are displayed.
Current attribute modes (page 117): Invisible=current
Constant=current Verify=current Preset=current Lock position=current
Annotative =current Multiple line =current
Enter an option to change
[Invisible/Constant/Verify/Preset/Lock
position/Annotative/Multiple lines] <done>:
Enter
attribute tag name (page 118): Enter any characters except spaces
or exclamation points
Enter
attribute value (page 119): Enter the appropriate text or press
Enter (this prompt is displayed only if you turned on Constant mode)
Enter
attribute prompt (page 118): Enter the text for the prompt line or
press Enter (this prompt is not displayed if you turned on Constant mode)
Enter
default attribute value (page 118): Enter the appropriate text
or press Enter (this prompt is not displayed if you turned on Constant mode)
Specify
location of multiline attribute (page 119): Specify a
point (this prompt is displayed only if you turned on Multiple line mode)
Specify
opposite corner (page 119): Specify a point or enter an option
(this prompt is displayed only if you turned on Multiple line mode)
Attribute Modes
The current value line indicates the current settings for each attribute mode
(either Y for on or N for off). Entering i, c, v, p, l, a, or m toggles the modes
on or off. Press Enter when you have finished adjusting the mode settings.
The
AFLAGS (page 1204) system variable stores the current mode settings and
can be used to set the default modes.
Invisible Specifies that attribute values are displayed when you insert the
block.
ATTDISP (page 119) overrides Invisible mode.
Constant Gives attributes a fixed value for block insertions.
A Commands | 117