2013

NOTE SPLKNOTS always defaults to 0 when AutoCAD starts.
See also:
Modify Splines
SPLMETHOD
Stores whether the default method used for the SPLINE command is fit points
or control vertices.
IntegerType:
Not-savedSaved in:
0Initial value:
Create splines using fit points0
Create splines using control vertices1
NOTE SPLMETHOD always defaults to 0 when AutoCAD starts.
See also:
Draw Splines
SPLPERIODIC
Controls whether closed splines and NURBS surfaces are generated with
periodic properties to maintain the smoothest continuity at the closure point
or seam.
IntegerType:
User-settingsSaved in:
1Initial value:
Creates closed splines and NURBS surfaces with the method used
in AutoCAD 2011 and earlier releases.
0
Creates periodic closed splines and closed NURBS surfaces, for
the smoothest (C2) continuity. (Recommended)
1
1490 | Chapter 4 System Variables