2013

SHORTCUTMENU
Controls whether Default, Edit, and Command mode shortcut menus are
available in the drawing area.
IntegerType:
RegistrySaved in:
11Initial value:
The setting is stored as a bitcode using the sum of the following values:
Disables all Default, Edit, and Command mode shortcut menus,
restoring AutoCAD Release 14 behavior.
0
Enables Default mode shortcut menus.1
Enables Edit mode shortcut menus.2
Enables Command mode shortcut menus whenever a command is
active.
4
Enables Command mode shortcut menus only when command
options are currently available at the Command prompt.
8
Enables the display of a shortcut menu when the right button on
the pointing device is held down long enough.
16
NOTE When this system variable is set to a value greater than 15, the SHORTCUT-
MENUDURATION
(page 1471) system variable determines the length of time that
the right button on the pointing device must be held down to display a shortcut
menu.
See also:
Set Up the Drawing Area
SHORTCUTMENUDURATION
Specifies how long the right button on a pointing device must be pressed to
display a shortcut menu in the drawing area.
S System Variables | 1471