2013

1Initial value:
No special linetype scaling. Linetype dash lengths are based on the
drawing units of the space (model or paper) in which the objects
were created. Scaled by the global LTSCALE (page 596) factor.
0
Viewport scaling governs linetype scaling. If TILEMODE (page 1511)
is set to 0, dash lengths are based on paper space drawing units,
1
even for objects in model space. In this mode, viewports can have
varying magnifications, yet display linetypes identically. For a specific
linetype, the dash lengths of a line in a viewport are the same as
the dash lengths of a line in paper space. You can still control the
dash lengths with LTSCALE
When you change PSLTSCALE or use a command such as
ZOOM (page 1188)
with PSLTSCALE set to 1, objects in viewports are not automatically regenerated
with the new linetype scale. Use the REGEN (page 889) or REGENALL (page
889) command to update the linetype scales in each viewport.
See also:
Scale Linetypes in Layout Viewports
PSOLHEIGHT
Controls the default height for a swept solid object created with the
POLYSOLID command.
RealType:
DrawingSaved in:
4.0000 (imperial) or 80.0000 (metric)Initial value:
The value reflects the last entered height value when using the
POLYSOLID
(page 834) command. You cannot enter 0 as the value.
See also:
Create a Polysolid
1450 | Chapter 4 System Variables