2013

RegistrySaved in:
0Initial value:
Direction of polyline is reversed; order of
polyline segment widths is not reversed
0
Order and direction of polyline segments
are reversed
1
Polylines are reversed with the REVERSE command.
See also:
Modify Polylines
PLINETYPE
Specifies whether optimized 2D polylines are used.
IntegerType:
RegistrySaved in:
2Initial value:
PLINETYPE controls both the creation of new polylines with the PLINE
command and the conversion of existing polylines in drawings from previous
releases.
Polylines in older drawings are not converted when opened; PLINE
creates old-format polylines
0
Polylines in older drawings are not converted when opened; PLINE
creates optimized polylines
1
Polylines in AutoCAD Release 14 or older drawings are converted
when opened; PLINE creates optimized polylines
2
For more information on the two formats, see the
CONVERT (page 226)
command.
PLINETYPE also controls the polyline type created with the following
commands:
BOUNDARY (page 154) (when object type is set to Polyline),
P System Variables | 1437