2013

ORTHOMODE
Constrains cursor movement to the perpendicular.
IntegerType:
DrawingSaved in:
0Initial value:
When ORTHOMODE is turned on, the cursor can move only horizontally or
vertically relative to the UCS and the current grid rotation angle
Turns off Ortho mode0
Turns on Ortho mode1
See also:
Use Orthogonal Locking (Ortho Mode)
OSMODE
Sets running object snaps
IntegerType:
RegistrySaved in:
4133Initial value:
The setting is stored as a bitcode using the sum of the following values:
NONe0
ENDpoint1
MIDpoint2
CENter4
NODe8
QUAdrant16
O System Variables | 1421