2013

StringType:
Not-savedSaved in:
VariesInitial value:
See also:
Open a Drawing
LONGITUDE
Specifies the longitude of the drawing model in decimal format.
RealType:
DrawingSaved in:
-122.3940Initial value:
The default is the longitude of San Francisco, California. The valid range is
-180 to +180. Positive values represent east longitudes.
This value is affected by the settings of the LUPREC system variable.
This value is not affected by the settings of the AUNITS and AUPREC system
variables.
See also:
Specify Units and Unit Formats
LTSCALE
Sets the global linetype scale factor.
RealType:
DrawingSaved in:
1.0000Initial value:
The linetype scale factor cannot equal zero. This system variable has the same
name as a command. Use the SETVAR command to access this system variable.
See also:
Control Linetype Scale
1402 | Chapter 4 System Variables