2013

LOFTANG2
Sets the draft angle through the last cross section in a loft operation.
RealType:
DrawingSaved in:
90Initial value:
The 0 direction is measured outward from the curve on the plane of the curve.
The positive direction is measured toward the previous cross section. Valid
values include 0 to less than 360.
See also:
Create a Solid or Surface by Lofting
LOFTMAG1
Sets the magnitude of the draft angle through the first cross section in a loft
operation.
RealType:
DrawingSaved in:
0.0000Initial value:
Controls how soon the surface starts bending back toward the next cross
section.
See also:
Create a Solid or Surface by Lofting
LOFTMAG2
Sets the magnitude of the draft angle through the last cross section in a loft
operation.
RealType:
DrawingSaved in:
0.0000Initial value:
Controls how soon the surface starts bending back toward the next cross
section.
1396 | Chapter 4 System Variables