2013

Regardless of the LAYOUTREGENCTL setting, if you redefine a block or undo
a layout switch, the drawing is regenerated the first time you switch to any
layout that contains saved viewports.
See also:
Work on a Named Layout
LEGACYCTRLPICK
Specifies the keys for selection cycling and the behavior for Ctrl-click.
IntegerType:
RegistrySaved in:
2Initial value:
Ctrl-click is used to select subobjects (faces, edges, and vertices) on
3D solids, surfaces, and meshes.
0
Ctrl-click is used to cycle through overlapping objects. Disallows
using Ctrl-click to select subobjects on 3D solids, surfaces, and
meshes.
1
Ctrl-click is used to select subobjects (faces, edges, and vertices) on
3D solids, surfaces, and meshes when SUBOBJSELECTIONMODE
2
(page 1494) is set to 0.If SUBOBJSELECTIONMODE is set to 1, 2, 3, or
4, it is not necessary to hold down the Ctrl key to select subobjects.If
you hold down the Ctrl key when SUBOBJSELECTIONMODE is set
to 1, 2, 3, or 4, the subobject filter is turned off until the Ctrl key is
released.
See also:
Select Objects Individually
SUBOBJSELECTIONMODE (page 1494)
Cycle Through and Filter Subobjects
LENSLENGTH
Stores the length of the lens (in millimeters) used in perspective viewing.
1390 | Chapter 4 System Variables