2013

2D-pointType:
DrawingSaved in:
0.0000,0.0000Initial value:
See also:
Control the Hatch Origin Point
HPORIGINMODE
Controls how the default hatch origin point is determined.
IntegerType:
RegistrySaved in:
0Initial value:
Uses HPORIGIN0
Uses the bottom-left corner of the rectangular extents of the hatch
boundaries
1
Uses the bottom-right corner of the rectangular extents of the hatch
boundaries
2
Uses the top-right corner of the rectangular extents of the hatch
boundaries
3
Uses the top-left corner of the rectangular extents of the hatch
boundaries
4
Uses the center of the rectangular extents of the hatch boundaries5
See also:
Control the Hatch Origin Point
HPQUICKPREVIEW
Controls whether a hatch preview is displayed when specifying a hatch area.
1366 | Chapter 4 System Variables