2013

This command is equivalent to the Polar option in ARRAY (page 81).
After selecting objects to array and a center point for the array, the
Create
Array visor for polar arrays
(page 106) is displayed.
You can also use the Properties Inspector to set the properties of the new array
while it is being created.
List of Prompts
The following prompts are displayed.
Select objects: Use an object selection method
Specify
center point (page 104) of array or [Base point (page
104)/
Axis of rotation (page 104)]: Specify a center point, or enter an
option
Select grip to edit array or [
ASsociative (page 105)/Base
point/
Items (page 105)/Angle between (page 105)/Fill angle
(page 105)/ROWs (page 105)/Levels (page 105)/ROTate items (page
106)/
eXit (page 106)]<eXit>: Select a grip or an option
Center Point
Specifies the point around which to distribute the array items. The axis of
rotation is the Z axis of the current UCS.
Base Point
Specifies a base point for the array.
Base Point Specifies a base point for positioning the objects in the array.
Key Point For associative arrays, specifies a valid constraint (or key point) on
the source objects to use as the base point. If you edit the source objects of
the resulting array, the base point of the array remains coincident with the
key point of the source objects.
Axis of Rotation
Specifies a custom axis of rotation defined by two specified points.
104 | Chapter 2 Commands