2013

When all features are on, the context governs what is displayed.
When DYNMODE is set to a negative value, the Dynamic Input features are
not turned on, but the setting is stored. Press the Dynamic Input button in
the status bar to set DYNMODE to the corresponding positive value.
All Dynamic Input features, including dynamic prompts, off0
Pointer input on1
Dimensional input on2
Both pointer input and dimensional input on3
If dynamic prompts are on (
DYNPROMPT (page 1320) is set to 1), they are
displayed when DYNMODE is set to 1, 2, or 3.
When dimensional input is turned on (DYNMODE = 2 or 3), the program
switches to pointer input when you enter a comma or an angle bracket (<),
or when you select multiple grip points.
When DYNMODE is set to 1, 2, or 3, you can turn off all features temporarily
by holding down the temporary override key, Fn-F12.
Settings are on the Dynamic Input tab in the
Drafting Settings dialog box
(page 369).
See also:
Use Dynamic Input
DYNPICOORDS
Controls whether pointer input uses relative or absolute format for coordinates.
SwitchType:
RegistrySaved in:
0Initial value:
Relative0
Absolute1
1318 | Chapter 4 System Variables