2013

Table Of Contents
See also:
Create Single-Line Text
DWGCHECK
Checks drawings for potential problems when opening them.
IntegerType:
RegistrySaved in:
1Initial value:
If a drawing that you try to open has a potential problem, you are
warned before the drawing is opened.
0
If a drawing that you try to open has a potential problem, or if it
was saved by an application other than one released by Autodesk
or based on RealDWG, you are warned before the drawing is opened.
1
If a drawing that you try to open has a potential problem, you are
notified at the Command prompt.
2
If a drawing that you try to open has a potential problem, you are
notified at the Command prompt. If the drawing has a potential
3
problem and the drawing was saved by an application other than
one released by Autodesk or based on RealDWG, you are warned
before the drawing is opened.
See also:
Open a Drawing
DWGCODEPAGE
Stores the same value as SYSCODEPAGE (for compatibility reasons).
(Read-only)
StringType:
Not-savedSaved in:
VariesInitial value:
D System Variables | 1313