Manualshelf

2013

ManualsBrandsAutodesk ManualsApplicationsAutoCAD for Macintosh
1341134213431344134513461347134813491350
Table Of Contents
This setting affects new mesh wedges that are created with the MESH (page
620) command.
See also:
Create a Mesh Wedge
DIVMESHWEDGEWIDTH
Sets the number of subdivisions for the width of the mesh wedge along the
Y axis.
IntegerType:
User-settingsSaved in:
3Initial value:
This setting affects new mesh wedges that are created with the MESH (page
620) command.
See also:
Create a Mesh Wedge
DONUTID
Sets the default for the inside diameter of a donut.
RealType:
Not-savedSaved in:
1308 | Chapter 4 System Variables