2013

Places the dimension text to conform to Japanese Industrial Stand-
ards (JIS).
3
Places the dimension text below the dimension line.4
See also:
Control the Location of Dimension Text
DIMTDEC
Sets the number of decimal places to display in tolerance values for the primary
units in a dimension.
IntegerType:
DrawingSaved in:
4 (imperial) or 2 (metric)Initial value:
This system variable has no effect unless DIMTOL is set to On. The default for
DIMTOL is Off.
See also:
Display Lateral Tolerances
DIMTFAC
Specifies a scale factor for the text height of fractions and tolerance values
relative to the dimension text height, as set by DIMTXT.
RealType:
DrawingSaved in:
1.0000Initial value:
For example, if DIMTFAC is set to 1.0, the text height of fractions and
tolerances is the same height as the dimension text. If DIMTFAC is set to
0.7500, the text height of fractions and tolerances is three-quarters the size
of dimension text.
See also:
Set the Scale for Dimensions
1282 | Chapter 4 System Variables