2013

See also:
Control Dimension Lines
DIMLWE
Assigns lineweight to extension lines.
EnumType:
DrawingSaved in:
-2Initial value:
Default (the LWDEFAULT (page 1404) value)-3
BYBLOCK-2
BYLAYER-1
The integer represents 1/100th of a mm.
See also:
Control Extension Lines
DIMPOST
Specifies a text prefix or suffix (or both) to the dimension measurement.
StringType:
DrawingSaved in:
NoneInitial value:
For example, to establish a suffix for millimeters, set DIMPOST to mm; a
distance of 19.2 units would be displayed as 19.2 mm.
If tolerances are turned on, the suffix is applied to the tolerances as well as to
the main dimension.
Use <> to indicate placement of the text in relation to the dimension value.
For example, enter <>mm to display a 5.0 millimeter radial dimension as
"5.0mm". If you entered mm <>, the dimension would be displayed as "mm
5.0". Use the <> mechanism for angular dimensions.
1276 | Chapter 4 System Variables