2013

DrawingSaved in:
. (imperial) or , (metric)Initial value:
When prompted, enter a single character at the Command prompt. If
dimension units is set to Decimal, the DIMDSEP character is used instead of
the default decimal point. If DIMDSEP is set to NULL (default value, reset by
entering a period), the decimal point is used as the dimension separator.
See also:
Control the Display of Dimension Units
DIMEXE
Specifies how far to extend the extension line beyond the dimension line.
RealType:
DrawingSaved in:
0.1800 (imperial) or 1.2500 (metric)Initial value:
See also:
Control Extension Lines
DIMEXO
Specifies how far extension lines are offset from origin points.
RealType:
DrawingSaved in:
0.0625 (imperial) or 0.6250 (metric)Initial value:
With fixed-length extension lines, this value determines the minimum offset.
See also:
Control Extension Lines
DIMFRAC
Sets the fraction format when DIMLUNIT is set to 4 (Architectural) or 5
(Fractional).
D System Variables | 1269