2013

The precision is based on the units or angle format you have selected. Specified
value is applied to angular dimensions when
DIMADEC (page 1254) is set to -1.
See also:
Control the Display of Dimension Units
DIMDLE
Sets the distance the dimension line extends beyond the extension line when
oblique strokes are drawn instead of arrowheads.
RealType:
DrawingSaved in:
0.0000Initial value:
See also:
Control Dimension Lines
DIMDLI
Controls the spacing of the dimension lines in baseline dimensions.
RealType:
DrawingSaved in:
0.3800 (imperial) or 3.7500 (metric)Initial value:
Each dimension line is offset from the previous one by this amount, if
necessary, to avoid drawing over it. Changes made with DIMDLI are not
applied to existing dimensions.
See also:
Control Dimension Lines
DIMDSEP
Specifies a single-character decimal separator to use when creating dimensions
whose unit format is decimal.
Single-characterType:
1268 | Chapter 4 System Variables