2013

DIMBLK2
Sets the arrowhead for the second end of the dimension line when DIMSAH
is on.
StringType:
DrawingSaved in:
""Initial value:
To return to the default, closed-filled arrowhead display, enter a single period
(.). For a list of arrowhead entries, see DIMBLK.
NOTE Annotative blocks cannot be used as custom arrowheads for dimensions or
leaders.
See also:
Customize Arrowheads
DIMCEN
Controls drawing of circle or arc center marks and centerlines by the
DIMCENTER, DIMDIAMETER, and DIMRADIUS commands.
RealType:
DrawingSaved in:
0.0900 (imperial) or 2.5000 (metric)Initial value:
For DIMDIAMETER and DIMRADIUS, the center mark is drawn only if you
place the dimension line outside the circle or arc.
No center marks or lines are drawn0
Centerlines are drawn<0
Center marks are drawn>0
The absolute value specifies the size of the center mark or centerline.
The size of the centerline is the length of the centerline segment that extends
outside the circle or arc. It is also the size of the gap between the center mark
and the start of the centerline.
D System Variables | 1265