2013

Table Of Contents

CONVTOSURFACE, CONVTONURBS, and CONVTOMESH com-

mands.

This setting also applies to options in commands such as REGION,

SPLINE, and ARRAY. The range of non-zero values is present to

maintain AutoCAD compatibility.

Displays prompts to delete profile curves, including those used with

the EXTRUDE, SWEEP, REVOLVE, and LOFT commands. Prompts to

remove cross sections used with the LOFT command.

-1

The original geometry for CONVTOSOLID, CONVTOSURFACE, and

CONVTOMESH commands is removed without prompting.

Displays prompts to delete all defining geometry, including paths

and guide curves used with the SWEEP and LOFT commands.

-2

The original geometry for CONVTOSOLID, CONVTOSURFACE, and

CONTOMESH commands is removed without prompting.

Displays prompts to delete all defining geometry if the resulting

entities are a surface of any type. Deletes all original geometry res-

-3

ulting in a solid entity, original geometry for CONVTOSOLID,

CONVTOSURFACE, CONVTONURBS, and CONVTOMESH commands

is removed without prompting.