2013

StringType:
RegistrySaved in:
ByColorInitial value:
When the drawing is opened and
PSTYLEPOLICY (page 1451) is set to 1
(color-dependent plot style mode), DEFPLSTYLE is read-only and has a value
of “BYCOLOR.” If PSTYLEPOLICY is set to 0 (named plot style mode),
DEFPLSTYLE is writable and has a default value of “BYLAYER.”
See also:
Overview of Plot Styles
DELOBJ
Controls whether geometry used to create other objects is retained or deleted.
IntegerType:
RegistrySaved in:
3Initial value:
If you use a product that supports creation of 3D models based on existing
geometry, use this system variable to control whether the original geometry
is retained or removed.
If the
SURFACEASSOCIATIVITY (page 1498) system variable is set to 1, the
DELOBJ setting is ignored.
All defining geometry is retained.0
Deletes profile curves, including those used with the EXTRUDE (page
427), SWEEP (page 1062), REVOLVE (page 913), and LOFT (page 585)
1
commands. Removes all defining geometry for CONVTOSOLID
(page 229), CONVTOSURFACE (page 232), CONVTONURBS (page
229), and CONVTOMESH (page 227) commands. Cross sections used
with the LOFT command are also deleted.
Deletes all defining geometry, including paths and guide curves
used with the SWEEP and LOFT commands.
2
Deletes all defining geometry, including paths and guide curves
used with the SWEEP and LOFT commands if the action results in a
3
solid object. Removes all defining geometry for CONVTOSOLID,
D System Variables | 1251