2013

 Selecting 3D objects by dragging selects only the objects that are normal in
the current view.
See also:
Cycle Through and Filter Subobjects
CURSORSIZE
Determines the size of the crosshairs as a percentage of the screen size.
IntegerType:
RegistrySaved in:
5Initial value:
Valid settings range from 1 to 100 percent. When set to 100, the crosshairs
are full-screen and the ends of the crosshairs are never visible. When less than
100, the ends of the crosshairs may be visible when the cursor is moved to
one edge of the screen.
See also:
Set Up the Drawing Area
CVPORT
Displays the identification number of the current viewport.
IntegerType:
DrawingSaved in:
2Initial value:
You can change this value, which changes the current viewport, if the
following conditions are met:
 The identification number you specify is that of an active viewport.
 A command in progress has not locked cursor movement to that viewport.
 Tablet mode is off.
See also:
Select and Use the Current Viewport
1244 | Chapter 4 System Variables