2013

counterclockwise rotation. A negative value specifies clockwise rotation. The
default value is 360. A value of 0 is not permitted.
Pick Angle to Fill Temporarily closes the Array dialog box so that you can
define the included angle between the base points of the first and last elements
in the array. ARRAY prompts you to select a point relative to another point
in the drawing area.
Angle Between Items
Sets the included angle between the base points of the arrayed objects and
the center of the array. Enter a positive value. The default direction value is
90.
NOTE You can choose the Pick buttons and use the pointing device to specify the
values for Angle to Fill and Angle Between Items.
Pick Angle Between Items Temporarily closes the Array dialog box so that
you can define the included angle between the base points of the arrayed
objects and the center of the array. ARRAY prompts you to select a point
relative to another point in the drawing area.
Rotation and Base Point
Specifies the rotation and object base point for the polar array.
Rotate Items as Copied Rotates the items in the array, as shown in the preview
area.
Use Object Base Point Uses the default base point of the object to position
the arrayed object. To manually set the base point, clear this option.
Base point settings by object
Default base pointObject type
Center pointArc, circle, ellipse
First cornerPolygon, rectangle
Starting pointDonut, line, polyline, 3D polyline, ray, spline
Insertion pointBlock, paragraph text, single-line text
MidpointConstruction lines
90 | Chapter 2 Commands