2013

B System Variables
BACKZ
Stores the back clipping plane offset from the target plane for the current
viewport, in drawing units.
(Read-only)
RealType:
DrawingSaved in:
0.0000Initial value:
Meaningful only if clipping is specified in
DVIEW (page 389). If there are several
cameras, the value is the last back clipping plane that you set current. The
distance of the back clipping plane from the camera point can be found by
subtracting BACKZ from the camera-to-target distance.
See also:
Create a 3D Dynamic View (DVIEW)
BINDTYPE
Controls how xref names are handled when binding xrefs or editing xrefs in
place.
IntegerType:
Not-savedSaved in:
0Initial value:
Traditional binding behavior ("xref1|one" becomes "xref$0$one")0
Insert-like behavior ("xref1|one" becomes "one")1
See also:
Archive Drawings That Contain Referenced Drawings (Bind)
1218 | Chapter 4 System Variables