2013

you can generate in one command is 100,000. The limit is set by the
MAXARRAY setting in the registry. To reset the limit to 200,000, for example,
enter (setenv "MaxArray" "200000") at the Command prompt.
Offset Distance and Angle
Provides a space for you to specify the distance and direction of the array's
offset.
Row Offset
Specifies the distance (in units) between rows. To add rows downward, specify
a negative value. To specify row spacing with the pointing device, use the Pick
Both Offsets button or the Pick Row Offset button.
Column Offset
Specifies the distance (in units) between columns. To add columns to the left,
specify a negative value. To specify column spacing with the pointing device,
use the Pick Both Offsets button or the Pick Column Offset button.
Angle of Array
Specifies the angle of rotation. This angle is normally 0, so the rows and
columns are orthogonal with respect to the X and Y drawing axes of the current
UCS. You can change the measurement conventions for angles using UNITS
(page 1130). The ANGBASE (page 1205) and ANGDIR (page 1205) system variables
affect the angle of arrays.
Pick Row Offset
Temporarily closes the Array dialog box so that you can use the pointing
device to specify the distance between rows. ARRAY prompts you to specify
two points and uses the distance and direction between the points to specify
the value in Row Offset.
Pick Column Offset
Temporarily closes the Array dialog box so that you can use the pointing
device to specify the distance between columns. ARRAY prompts you to specify
two points and uses the distance and direction between the points to specify
the value in Column Offset.
Pick Angle of Array
Temporarily closes the Array dialog box so that you can specify the angle of
rotation by entering a value or using the pointing device to specify two points.
You can change the measurement conventions for angles using
UNITS (page
1130). The
ANGBASE (page 1205) and ANGDIR (page 1205) system variables affect
the angle of arrays.
88 | Chapter 2 Commands