2013

Table Of Contents

Use Running Object Snaps

Using the OSNAP (page 747) or DSETTINGS (page 368) commands, you can

specify a set of running object snaps. Running object snaps are one or more

object snaps that remain in effect as you work.

 To turn running object snaps on and off, click the OSNAP button on the

status bar or press F3.

 Press TAB to cycle through the object snap possibilities before you specify

the point.

 To turn off running object snaps for the next point only, specify the None

object snap.

Selection Modes (Command Modifier)

Controls how you create selection sets

Command entry: At a prompt to select objects, enter one of the valid selection

modes described in the SELECT command

The selection mode you enter remains active only for the current Select Objects

prompt.