2013

Specify corner of window, enter a scale factor (nX or nXP),
or
[
All (page 1189)/Center (page 1189)/Dynamic (page 1189)/Extents
(page 1190)/Previous (page 1190)/Scale (page 1190)/Window (page
1191)/
Object (page 1191)] <real time (page 1191)>
All Zooms to display all visible objects and visual aids.
Adjusts the magnification of the drawing area to accommodate the extents
of all visible objects in the drawing, or visual aids such as the grid limits (the
LIMITS (page 575) command), whichever is larger.
In the illustration on the right, the grid limits are set to a larger area than the
extents of the drawing.
Because it always regenerates the drawing, you cannot use ZOOM All
transparently.
Center Zooms to display a view defined by a center point and a magnification
value or a height. A smaller value for the height increases the magnification.
A larger value decreases the magnification. Not available in perspective
projection.
Dynamic Pans and zooms using a rectangular view box. The view box
represents your view, which you can shrink or enlarge and move around the
drawing. Positioning and sizing the view box pans or zooms to fill the viewport
with the view inside the view box. Not available in perspective projection.
Z Commands | 1189