2013

Insertion Point
Specify On-Screen Allows you to input at the Command prompt or the
pointing device.
X Sets the X coordinate value.
Y Sets the Y coordinate value.
Z Sets the Z coordinate value.
Scale
Specify On-screen Allows you to input at the Command prompt or the
pointing device.
X Sets the X scale factor.
Y Sets the Y scale factor.
Z Sets the Z scale factor.
Uniform Scale Sets the Y and X scale factors as the same as Z.
Rotation
Specify on-screen If Specify On-Screen is selected, you may wait until you
exit the dialog box to rotate the object with your pointing device or at the
Command prompt.
Angle If Specify On-Screen is cleared, enter the rotation angle value in the
dialog box.
Path Type
Select the full (absolute) path, the relative path to the external reference file,
or No Path, the name of the external reference (the file must be located in the
same folder as the current drawing file).
Details
Displays block and path information about the external reference being
attached.
Block Displays information about the block in the drawing.
 Unit. Displays the specified
INSUNITS (page 1373) value for the inserted
block.
 Factor. Displays the unit scale factor, which is calculated based on the
INSUNITS (page 1373) value of the block and the drawing units.
Path Displays the external reference file paths.
 Found In. Displays the path where the external reference file is located.
1174 | Chapter 2 Commands