2013

The view orientation of the specified orthographic view is based on the UC-
SBASE
(page 1525) system variable, which is set to the world coordinate system
by default. When one of the orthographic views is restored, the program zooms
to the extents in the current viewport.
Restore Restores the view you specify to the current viewport. If a UCS setting
was saved with the view, it is also restored.
The center point and magnification of the saved view are also restored. If you
restore a model space view while working in paper space, you are prompted
to select a viewport in which to restore that view.
Select the viewport by clicking its border. The viewport you select must be on
and active. The program switches to model space and restores the view in the
selected viewport.
If you restore a paper space view while working in model space in a layout
tab, the program switches to paper space and restores the view. You can't
restore a paper space view if you are working in the Model tab.
Save Saves the display in the current viewport using the name you supply.
The current value of the
UCSVIEW (page 1529) system variable is displayed when
you save a view. To change the setting and turn this option on or off, use the
UCS option of VIEW.
Settings Specifies various settings for the VIEW command.
Background Specifies background the for view. Backgrounds are visible in a
3D visual style only.
Categorize Specifies a category for the named view.
Layer Snapshot Saves the current layer visibility settings with the new named
view.
Live Section For model views only, specifies the live section applied when
the view is restored.
1140 | Chapter 2 Commands