2013

Table Of Contents

Toolbar: Modeling tool set  Surfaces - Edit tool group  Surface Fillet

Menu: Draw  3D Modeling  Surfaces  Fillet

Summary

The fillet surface has a constant radius profile and is tangent to the original

surfaces. The original surfaces are automatically trimmed to connect the edges

of the fillet surface.

List of Prompts

The following prompts are displayed.

First and Second Surface or Region Specifies the first and second surfaces or

regions.

Radius Specifies fillet radius. Use the Fillet grip or enter a value to change the

radius. You cannot enter a value that is smaller than the gap between the

surfaces. If no radius value is entered, the

FILLETRAD3D (page 1335) system

variable value is used.

Trim Surface Trims the original surfaces or regions to the edges of the fillet

surface.

Expression Enter a formula or equation to specify the fillet radius. See

Constrain a Design with Formulas and Equations.