2013

End Tangency Specifies a tangent condition on the ending point of the spline.
Tolerance Specifies the distance by which the spline is allowed to deviate
from the specified fit points. A tolerance value of 0 requires the resulting spline
to pass directly through the fit points. The tolerance value applies to all fit
points except the starting and ending fit points, which always have a tolerance
of 0.
Options for Splines with Control Vertices
The following option is specific to the control vertices (CV) method.
(
SPLMETHOD (page 1490) system variable)
Degree Sets the polynomial degree of the resulting spline. Use this option to
create splines of degree 1 (linear), degree 2 (quadratic), degree 3 (cubic), and
so on up to degree 10.
See also:
Draw Splines
1026 | Chapter 2 Commands