2013

List of Prompts
The following prompts are displayed.
Specify
center point (page 1021) or [3P (page 1021)/2P (page
1021)/
Ttr (page 1022)]: Specify a point or enter an option
Center Point
Specifies the center point of the sphere.
When you specify the center point, the sphere is positioned so that its central
axis is parallel to the Z axis of the current user coordinate system (UCS).
Latitudinal lines are parallel to the XY plane.
Radius Defines the radius of the sphere.
Diameter Defines the diameter of the sphere.
3P (Three Points)
Defines the circumference of the sphere by specifying three points anywhere
in 3D space. The three specified points also define the plane of the
circumference.
2P (Two Points)
Defines the circumference of the sphere by specifying two points anywhere
in 3D space. The plane of the circumference is defined by the Z value of the
first point.
S Commands | 1021