2013

Two points define the inclined plane used for the auxiliary projection. Both
points must be located in the same viewport.
A rubber-band line perpendicular to the inclined plane helps you select the
center of the new viewport.
Section
Creates a drafting sectional view of solids, complete with cross-hatching. When
you use
SOLDRAW (page 988) on a sectional view created with this option, it
creates a temporary copy of the solids and uses
SLICE (page 981) to perform
the operation at the cutting plane that you define. SOLDRAW then generates
a profile of the visible half of the solids and discards the original copy. Finally
SOLDRAW sections the solids. Solids not crossing the cutting plane are
generated as full profiles. Because drafting standards recommend not drawing
hidden lines in sectional views, SOLVIEW freezes the View Name-HID layer.
S Commands | 1013