2013

 Add. Press Ctrl+click an edge to indicate which faces to retain.
 All. Temporarily selects all faces for removal. You can then use Add to
add the faces you want to retain.
Enter the shell offset distance Sets the size of the offset. Specify a positive
value to create a shell to the inside perimeter of the solid. Specify a negative
value to create a shell on the outside perimeter of the solid.
Body: Clean
Removes shared edges or vertices having the same surface or curve definition
on either side of the edge or vertex. Removes all redundant edges, vertices,
and unused geometry. Does not remove imprinted edges.
In unusual circumstances, this option removes shared edges or vertices having
the same surface or curve definition on either side of the edge or vertex.
Select a 3D solid (clean) Specifies a 3D solid object that you want to clean.
Body: Check
Validates the 3D solid object as a valid solid, independent of the
SOLIDCHECK
(page 1485) setting.
 Select a 3D object (check). Specifies the 3D solid object to be validated.
If the object is valid, the following prompt is displayed:
This object is a valid ShapeManager solid.
This option is used as a debugging tool to compare stages in a highly complex
3D solid model.
Body: Undo
Undoes the editing action.
Body: Exit
Exits the face-editing options and displays the Enter a Solids Editing Option
prompt.
1006 | Chapter 2 Commands