2013

 Undo (page 1003)
 Remove (page 1003)
Select Edges (copy) Specifies the edges to copy. Press Ctrl+click to select the
edge. Then set the displacement:
 Base point of displacement. Sets the first point for determining where
the new object is placed.
 Second point of displacement. Sets the relative direction and distance
for the new object.
Undo Cancels selection of the edges you added most recently to the selection
set. The previous prompt is displayed. If all edges have been removed, the
following prompt is displayed:
Remove Removes previously selected edges from the selection set. The prompt
is redisplayed.
 Remove edges. Removes the edges you select from the current selection
set.
 Undo (page 1003)

Add (page 1003)
Add Adds edges to the selection set.

Select Edges (copy) (page 1003)

Undo (page 1003)

Remove (page 1003)
Edge: Color
Changes the color of individual edges on a 3D solid object.

Select edges (color) (page 1003)
 Undo (page 1003)
 Remove (page 1003)
Select edges (color)
Colored edges can be used to highlight intersections, interferences, or critical
clearances.
Press Ctrl+click to select the edge.
Edge: Undo
Reverses actions as far back as the beginning of the SOLIDEDIT session.
S Commands | 1003